New right hand (passenger's side) front to rear (full length) floor pan. This piece is made from the same gauge material as the original and manufactured from high-quality sheet metal. This floor pan is ready to weld into your classic car. It goes from the front of the car to a couple inches under the rear seat, but it does not extend to the rocker panel. It fits any 1978-1988 G-Body car.
This is the perfect replacement part if your floor pan is rusted or needing repair.
If ordering more than one large sheet metal piece, contact us at [email protected] for better shipping quotes.
SHEET METAL & SHIPPING DISCLAIMER: No two cars are ever exactly alike. We have had very good results with this part, but there is no way to guarantee that it will fit your car exactly. You may need to modify the part to fit your car just as GM did when the car was built. If you have not worked with sheet metal often, you should consider consulting a professional auto body technician for help. Truck freight shipments must be signed for by the recipient. Please inspect the shipment before signing for it and note any damage on the drivers bill. If the shipment has been damaged, call us immediately to report the problem. If you do not call within 24 hours, we may not be able to correct or rectify the issue.